Rockwell-automation 1762-IQ8 MicroLogix DC Input Module Manuel d'utilisateur télécharger pdf (Page 13)

MicroLogix™ 1762-IQ8 DC Input Module 13

1762-IN004A-US-P

Hazardous Location Considerations

This equipment is suitable for use in Class I, Division 2, Groups A, B, C, D or

non-hazardous locations only. The following ATTENTION statement applies to

use in hazardous locations.

ATTENTION:

EXPLOSION HAZARD

•

Substitution of components may impair suitability for Class I,

Division 2.

•

Do not replace components or disconnect equipment unless

power has been switched off.

•

Do not connect or disconnect components unless power has

been switched off.

•

This product must be installed in an enclosure.

•

In Class I, Division 2 applications, the bus connector must be

fully seated and the bus connector cover must be snapped in

place.

•

In Class I, Division 2 applications, all modules must be

mounted in direct contact with each other as shown on page 6.

If DIN rail mounting is used, an end stop must be installed

ahead of the controller and after the last 1762 I/O module.

1 2 ... 8 9 10 11 12 13 14 15 16

Pas de commentaire

Rockwell-automation 1762-IQ8 MicroLogix DC Input Module Manuel d'utilisateur Page 13