Rockwell-automation 1747-AENTR SLC to EtherNet/IP Adapter Installation Manuel d'utilisateur télécharger pdf (Page 12)

12 SLC 500 EtherNet/IP Adapter

Publication 1747-IN521B-EN-E - January 2013

Interpret the Status Indicators

The four-character display indicates module status as shown in the table below.

Indicator State Description

Module Off No power applied to device

Green Device operating normally

Flashing green Device has not been configured

Flashing red Recoverable fault.

• IP Address switches do not match configuration in use.

• The device has completed a reset to factory default request

because the switches were set to 888 at powerup, and a power

cycle is required.

• The device is performing a firmware flash update.

Red Unrecoverable fault, may require device replacement

4 Character Display Displays IP address and module status description.

See table, Four-character Status Display, for a description of all the

possible module status.

Link 1 or Link 2 Off No link established.

Solid green Link established @ 100 Mbps.

Flashing green Transmit or receive activity present on indicated port @ 100 Mbps.

Solid yellow Link established @ 10 Mbps.

Flashing yellow Transmit or receive activity present on indicated port @ 10 Mbps.

Four-character Status Display

MOD LED Display Description Probable Cause Recommended

Action

System startup

Red-green

flash

followed by

Solid Red

Dotted display on Module is

performing Power On

Self Test (POST)

None None

Green “OK”

(The first scroll cycle

displays the software

revision in the format

"Rev

majorRev.minorRev.

subMinorRev")

POST is successful None None

Red 4-digit error hex code

(For example, 0100 and

0101)

POST Failure

(0100 = IOFPGA

failure)

(0101=ESFPGA

failure)

The adapter has

either failed a

hardware test, or

gone into a state

from which it cannot

recover.

Document the

error codes.

Power cycle the

adapter. Contact

Technical

Support.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Rockwell-automation 1747-AENTR SLC to EtherNet/IP Adapter Installation Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Rockwell-automation 1747-AENTR SLC to EtherNet/IP Adapter Installation