Rockwell-automation 1609-ENET Ethernet Network Card Quick Start Manuel d'utilisateur télécharger pdf (Page 12)

12 Rockwell Automation Publication 1609-QS002A-EN-P - May 2014

Chapter 2 Ethernet Mode Setup

1. 1.Flip DIP switch number one to the UP position in order to enable Ethernet mode on the card.

2. Check that both of the DIP switches of the 1609 Network Management Card are set to 'OFF' position (normal

mode) to enable the network transmission.

3. Insert the card in the UPS ENET card slot. Note: This 1609-ENET card is hot swappable

4. Ensure you connect the Ethernet cable to the bottom Ethernet port.



1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 30 31

Pas de commentaire

Rockwell-automation 1609-ENET Ethernet Network Card Quick Start Manuel d'utilisateur Page 12