Rockwell-automation 1394C-SJT_CONN-KEY Installing Your Power Connector Manuel d'utilisateur télécharger pdf (Page 6)

6 Installing Your 1394C Power Connector Key Kit

Publication 1394-IN023A-EN-P — July 2000

Re-applying Power to Your 1394C System

To re-apply power to your 1394C system:

1. Re-connect the three connector plugs as shown in the table below

(refer to Figure 2 for connector locations

2. Re-apply power to your system.

3. Check for proper operation. Refer to your 1394 Digital AC

Multi-Axis Motion Control System User Manual (publication

1394-5.0) for additional start-up information.

Connect the plug

labeled:

Into this system module connector:

W1 W2 Input logic connector

U V W PE Input power connector

COL INT DC+ Shunt power connector

1 2 3 4 5 6 7 8

Pas de commentaire

Rockwell-automation 1394C-SJT_CONN-KEY Installing Your Power Connector Manuel d'utilisateur Page 6