Rockwell-automation Logix5000 Controllers Nonvolatile Memory Programmi Manuel d'utilisateur télécharger pdf (Page 18)

Chapter 1 Store and load a project by using a memory card

When the store operation is finished, you remain offline.

For procedures on loading and removing the SD card in the card slot, see

the ControlLogix System User Manual, publication 1756-UM001

Follow these steps to use the Logix Designer application to load the project from a

memory card.

ATTENTION: During a load operation, all active servo axes are turned off. Before you load a project, make

sure that this does not cause any unexpected movement of an axis.

Important:

Make sure the SD card is unlocked if set to load On Power Up before using the ControlFLASH

software. Otherwise, the updated data may be overwritten by firmware on the SD card. An error

message appears. See the ControlLogix System User Manual, publication 1756-UM001

before

updating.

1. Go online with the controller.

Load a project

18 Rockwell Automation Publication 1756-PM017F-EN-P – October 2014

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 32 33

Pas de commentaire

Rockwell-automation Logix5000 Controllers Nonvolatile Memory Programmi Manuel d'utilisateur Page 18